On the ground, some have been clocked at 32 km/h (20 mph) while a few have also been clocked up to 43 km/h (27 mph). Although capable of flight, roadrunners generally run away from predators. They are found in the southwestern and south-central United States and Mexico, usually in the desert. The roadrunners (genus Geococcyx), also known as chaparral birds or chaparral cocks, are two species of fast-running ground cuckoos with long tails and crests. For other uses, see Roadrunner (disambiguation). If the issue persists after completing the connector check, contact Rad Power Bikes Product Support.This article is about the bird. Reinstall the cable cover at the front of the bike. Once the connector check is complete, replace all zip ties snipped during the check, snip zip tie excess, and check that all cables are free from any moving parts. Use a 4 mm Allen wrench at the front of the bolt. Use a 4 mm Allen wrench to hold the back bolt in place, and an 8 mm wrench to tighten down the locknut. Pass the bolt up through the front of the skid mounting plate and spacer, and carefully thread into the mounting point on the frame, tightening partway (about 3-4 turns).Ĭ) Tighten both bolts evenly by alternating between them every few turns. Pass the bolt through the skid plate, pass a flat washer onto the bolt end, and thread on the locknut while holding the bolt in place with a 4 mm Allen wrench.ī) Pass the split washer and flat washer onto the front skid plate mounting bolt end. Reinstall the skid plate starting with the rear bolt near the kickstand. Ensure the cables are properly oriented to afford clearance.Ī) Pass the rear skid plate mounting bolt down through the kickstand mounting plate and spacer. Ensure the cut is flush and there are no sharp points that could damage cable housing.Ģ. Replace any zip ties that were removed and use flat side cutters to snip off zip tie excess. If the issue persists after checking all 10 connectors, or you find signs of moisture, debris, or damage, contact Rad Power Bikes Product Support.ġ. Turn on the battery and power on the bike to see if the issue is resolved. Reconnect the wiring harness connector. Align the internal notch and pins, and external arrows, and press directly together without twisting to fully seat the connection.Ħ. If you notice signs of moisture, debris, or damage, take photos to send to Rad Power Bikes Product Support as soon as possible.ĥ. Pull each side directly apart without twisting and inspect both sides of the connector. Use caution to avoid unplugging the connector while it is still in the frame, and gently pull the wiring harness cable to move the connector out of the opening.Ĥ. Unseat the rubber grommet, which is located at the lower cable opening in front of the bottom bracket.ģ. Locate the large wiring harness cable, and gently feed the cable into the opening at the front of the downtube to provide slack.Ģ. To access these connectors, unlock and remove the battery, discharge residual power, and follow the instructions within each section below.ġ. The remaining connectors are located below the battery, between the battery mounting tray (on the seat tube) and the skid plate (under the cranks at the bottom of the frame). If the issue persists, power off the bike, turn off the battery, discharge residual power, and read the instructions below on how to proceed to the next connector. Align the internal notch and pins (and external arrows) and press directly together without twisting to fully seat the connection.Ĥ. If you notice signs of moisture, debris, or damage, take photos to send to Rad Power Bikes Product Support as soon as possible.ģ. Pull each side of the connector directly apart without twisting and inspect both sides of the connector. Trace the cable coming out of the taillight at the rear of the bike to the connector.Ģ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |